Objective This study aimed to develop a novel method for encapsulating oocytes in sodium alginate hydrogel using microfluidics, then to vitrify these encapsulated oocytes in a single-step process with low concentrations of cryoprotectants.Methods We utilized a flow-focusing microfluidic chip to generate sodium alginate hydrogel microspheres. The influence of various parameters, including throat structure, cross-linking method, sodium alginate concentrations, and flow rate ratios on the stability diameter, and coefficient of variation of microspheres were examined. To further investigate the cold-resistance of these microspheres, we used cryomicroscopy to observe changes in volume and morphology of microspheres during cooling and warming processes. We used microfluidic chip to encapsulate oocytes in sodium alginate hydrogel microspheres, the empty rate of microspheres and loss rate of oocytes were determined. After releasing from microspheres and parthenogenetic activation with cytochalasin B and strontium chloride, the survival, cleavage and blastocyst rates were evaluated during in vitro maturation. Finally, oocytes encapsulated in sodium alginate microspheres were vitrified with low concentrations of cryoprotectants. We compared the survival and development capability of the oocytes with the Cryotop method.Results When the throat of the microfluidic chip measures 300 μm in length and 120 μm in width, microspheres can be uniformly formed at the throat of the chip. Sodium alginate generates microspheres with a wide size distribution when cross-linking outside the chip, while internal cross-linking within the chip results in more uniform microspheres. The stability of microsphere formation is significantly improved with the use of a three-channel internal cross-linking chip. At a flow rate of 2 μl/min and with 1% sodium alginate, the microfluidic chip can consistently and uniformly produce microspheres. Under flow rate ratios of 10, 15, and 20, the average microsphere diameters are 262.71 μm, 193.63 μm, and 156.63 μm, respectively. The sodium alginate hydrogel microspheres maintained their volume and structural integrity during the cooling and warming processes. Using a three-channel internal cross-linking microfluidic chip to encapsulate oocytes, at a flow rate ratio of 10, the empty rate is 32.28%, and the cell loss rate is 11.09%. After encapsulation and subsequent release, the oocyte survival rate (96.99%), cleavage rate (88.71%), and blastocyst formation rate (26.29%) showed no significant differences compared to the fresh group. After the microspheres were vitrified using a low concentration of cryoprotectant (10% DMSO+10% ehylene glycol (EG)+0.5 mol/L trehalose), the survival rate, cleavage rate, and blastocyst rate were 92.48%, 70.80%, and 20.42%, respectively. No significant difference was observed when compared to the Cryotop method using a higher concentration of cryoprotectant solution (15% DMSO+15% EG+0.5 mol/L trehalose).Conclusion We designed and fabricated a microfluidic system with three-channel internal cross-linking chips used for oocyte vitrification preservation. The microfluidic system can generate oocytes-loaded sodium alginate hydrogel microspheres with uniform size, low empty rate, and good cold-resistance. The method successfully reduced the concentration of cryoprotectants in a single-step vitrification process, the developmental capability of oocytes during in vitro maturation were comparable with Cryotop method. Unlike the Cryotop method, the oocytes encapsulated in hydrogel does not come into contact with liquid nitrogen, eliminating the risk of cross-contamination. This study provides a novel approach to oocyte vitrification.